FMM125 GSM Operators settings

From Wiki Knowledge Base | Teltonika
This is the approved revision of this page, as well as being the most recent.
Main Page > Fleet management > FMM125 > FMM125 Configuration > FMM125 GSM Operators settings

FMM125 can work in different modes (use different settings) according to the operator list defined. Operator list is used for Data Acquisition mode switching (see Data acquisition settings section for more details). Modes are changed based on GSM operator FMM125 is connected to.

FMB GSM-Operators-FMM125.jpg

If roaming operator list is left empty, FMM125 will automatically detect home operator. If home operator is written to the roaming operator list, it will still be detected as home operator. Any operator not in the roaming operator list (except the home operator) will be recognized as unknown operator and FMM125 will work in Unknown mode (make sure it is configured to allow data sending – GPRS context is enabled).
If user wants FMM125 to not connect and work with a particular operator it has to be written to Operator Blacklist. Up to 50 operators may be entered to this list.
Operator search procedure is initiated as normal every 15 minutes and tries to connect to an operator providing the strongest signal. It will prioritize operators which are specified in the operator list. If no operators from the operator list are available, the device will try to connect to an operator from the blacklist. If device connects to an operator from the blacklist, best operator search procedure is initiated instantly. During the time when device is connected to blacklisted operator no GPRS connection would be initiated and no data would be sent via GPRS. However, the ability to send SMS commands to the device would remain. If no suitable operator is found on both lists, the device will try to connect to a remaining available operator with the strongest signal.

Bw nb.png In SIM2 Roaming/Home Operator list home operator must be added to the any part of the list that functionality works correctly.
Fmb120 operator search.png

FMM125 has two SIM card slots. GPRS settings and Roaming Operators can be configured separately for SIM1 and SIM2. In SIM2 Roaming/Home Operator list home operator must be added to any part of the list to enable correct functionality. Dual SIM operator search functionality works the following way:

  • SIM1 and SIM2 home operators have the highest priority;
  • When device is connected to home operator, manual roaming operator search is disabled;
  • When device is disconnected from home operator, operator search procedure is initiated as normal every 15 minutes;
  • SIM1 Roaming Operators list has higher priority then SIM2 Roaming Operator list.
  • When the device finds a new operator from SIM1/SIM2 lists – it switches to new SIM according to the list and connects to the new operator.


Fmb120 dual sim.png