RUTX09 Realtime Graphs

From Wiki Knowledge Base | Teltonika
Main Page > Network products > RUTX09 > RUTX09 Manual > RUTX09 WebUI > RUTX09 Realtime Graphs

Summary[edit | edit source]

The Graphs section contains various graphs that display various statistical data changes in real time. This chapter is an overview of the Graphs section in RUTX09 routers.

Load[edit | edit source]

The Realtime Load section displays a tri-graph that illustrates average CPU load values in real time. The graph consists out of three color coded graphs, each one corresponding to the average CPU load over 1 (red), 5 (orange) and 15 (yellow) most recent minutes.

The figure below is an example of the Realtime Load graph:

Networking rutx manual realtime graphs load v1.png

Traffic[edit | edit source]

The Realtime Traffic graphs provide users with the possibility to monitor average inbound and outbound traffic over the course of 3 minutes. Each new measurement is taken every 3 seconds. The graphs consist out of two color coded graphs: the green graph shows the outbound traffic, the blue graph shows the inbound traffic. Although not graphed, the page also displays peak loads and averages of inbound and outbound traffic.

The figure below is an example of the Realtime traffic graph for the Bridge connection:


The figure below is an example of the Realtime traffic graph for the LAN connection:


The figure below is an example of the Realtime traffic graph for the wired WAN connection:


The figure below is an example of the Realtime traffic graph for the mobile (sim card slot 1) connection:


GRAPH DESCRIPTION
Bridge Cumulative graph, which encompasses wired Ethernet LAN and the wireless network
LAN Displays traffic that passes through the LAN network interface(s) in graph form
WANDisplays traffic that passes through the wired WAN connection in graph form
MobileDisplays traffic that passes through the mobile WAN connection in graph form

Wireless[edit | edit source]

The Realtime Wireless graph displays the wireless radio signal strength, signal noise, average and peak signal levels and the theoretical maximum channel permeability for all of the active wireless connections. The graph below the WiFi signal graph displays the Phy Rate for the wireless connection.

The figures below are examples of both Wireless graphs:


Networking rutx manual realtime graphs wireless 2 v1.png

Connections[edit | edit source]

The Realtime Connections graph displays currently active network connections with the information about network, protocol, source, destination addresses and transfer speed. The table below the graph displays basic information on active connections.

The figures below are examples of both of the Realtime Connections graph and the corresponding table: