Changes

Template:Networking rutx manual routing

72 bytes added, 18:29, 4 December 2019
===Static IPv4 Routes===
----
Below is an example and information about Static IPv4 Routes.
[[File:Networking_RUTX_manual_static_routes_ipv4_v1.png|alt=|border|left]]
Below is an example and information about Static IPv4 Routes.[[Image:Networking_RUTX_manual_static routes_ipv4_v1.png|border]]<table class="nd-mantable"><tr><th>Field</th><th>Value</th><th>Description</th></tr><tr><td>Interface</td><td>mobile | lan; default: <b>mobile</b></td><td>The zone where the target network resides</td></tr><tr><td>Target<span class="asterisk">*</span></td><td>ip4; default: <b>0.0.0.0</b></td><td>The address of the destination network</td></tr><tr><td>Netmask<span class="asterisk">*</span></td><td>netmask; default: <b>255.255.255.255</b></td><td>A Mask that is applied to the Target to determine to what actual IP addresses the routing rule applies</td></tr><tr><td>Gateway</td><td>ip; default: <b>none</b></td><td>Defines where the router should send all the traffic that applies to the rule</td></tr><tr><td>Metric</td><td>integer; default: <b>0</b></td><td>The <b>metric</b> value is used as a sorting measure. If a packet about to be routed fits two rules, the one with the lower metric is applied.</td></tr><tr><td>MTU</td><td>integer [64..9000]; default: <b>1500</b></td><td>Sets the maximum transmission unit (MTU) size. It is the largest size of a protocol data unit (PDU) that can be transmitted in a single network layer transaction.</td></tr><tr><td>Route Type</td><td>unicast | local | broadcast | multicast | unreachable | prohibit | backhole | anycast | -- custom -- ; default: <b>unicast</b></td><td>Selects route type. Each type specifies a different behavior for the route:<ul><li><b>unicast</b> -</li><li><b>local</b> - routes of this type are added to the 'local' routing table and used only for locally hosted IPs.</li><li><b>broadcast</b> - routes of this type are added to the 'local' routing table and used by link layer devices that support the broadcast address principle.</li><li><b>multicast</b> -</li><li><b>unreachable</b> -</li><li><b>prohibit</b> - used to prohibit traffic to specified host or network. When a destination is prohibited, the kernel sends a 'Network is unreachable' response the source address.</li><li><b>blackhole</b> - packets that match this type of route are discarded without any response.</li><li><b>anycast</b> -</li><li><b>-- custom --</b> -</li></ul></td></tr></table>
<span class="asterisk">*</span><b>Additional notes on Target & Netmask:</b>
===Static IPv6 Routes===
----
Settings for Static IPv6 routes are the same as for IPv4 only that the target IP and and gateway are different.
Settings for Static IPv6 routes are the same as for IPv4 only that the target IP and and gateway are different.
[[File:Networking_RUTX_manual_static_routes_ipv6_v1.png|border]]
==Dynamic Routes==
 
===BGP Protocol===
----
[[Image:Network routing Networking RUTX manual dynamic routes bgp generalv1.PNGpng|border]]
<table class="nd-mantable">
<tr>
<td>Enable</td>
<td>yes off | noon; Default: '''nooff'''</td>
<td>Toggles the BGP protocol ON or OFF</td>
</tr>
<tr>
<td>Enable vty</td>
<td>yes off | noon; Default: '''nooff'''</td>
<td>Toggles vty access from LAN ON or OFF</td>
</tr>
----
[[Image:Network routing Networking RUTX manual dynamic routes bgp instancev1.PNGpng|border]]
<table class="nd-mantable">
----
[[Image:Network routing Networking RUTX manual dynamic routes bgp peersv1.PNGpng|border]]
<table class="nd-mantable">
----
[[Image:Network routing Networking RUTX manual dynamic routes bgp access list filtersv1.PNGpng|border]]
<table class="nd-mantable">

Navigation menu