TMT250 User interface

From Wiki Knowledge Base | Teltonika
This is the approved revision of this page, as well as being the most recent.
Main Page > Smart Autonomous Solutions > TMT250 > TMT250 Configuration > TMT250 User interface

Indication is configurable in User Interface tab of configurator or via SMS/GPRS parameter ID. Each 100 ms device checks if any indication is enabled in response to triggered scenarios. If two scenarios need to indicate on the same indication source (LED or Vibration) then the active indicating scenario needs to be finished first (with exception of Alarm, Power Key Pressed and Device Off scenarios, which can override the control of indication sources). An example of indication configuration is given in the picture shown below. Period setting is indicative of Periodic scenarios (refer to the table below) and if Period is set to 0 the indication will take place immediately. When indication is periodic and On parameter value is set to 0, the indication source will stay on until the scenario is finished. Triggered scenarios will turn on LED and/or Vibration for a configured On duration and then keep them off for a configured Off period of time. In case the configured Repeat value is higher than 0 the device continues a periodic on/off cycle.

Tmt250 user interface.png


Name Type Trigger
GSM Error Periodic SIM is not inserted, blocked, failed to connect to an operator or jammed
GSM Registering Periodic Trying to register to GSM network
SMS Send/Received One Off SMS is being received or sent
Outgoing Call Periodic Outgoing call is in process
Remote Connection Periodic Device is connected to the server
Event One Off An event record is saved
Panic Event One Off A panic event record is saved
No GPS Fix Periodic Device tries to obtain valid GPS fix
GPS Fix Periodic Device has valid GPS fix
Device Off One Off Device is turning off
Device On One Off Device is turning on
Power Key Pressed Periodic Alarm button is pressed and held down
Power Key Pressed Periodic Power button is pressed and held down
Function Activated One Off Configured functionality was activated by pressed button
Function Deactivated One Off Configured functionality was deactivated by pressed button
Charging Periodic Device is charging
Fully Charged Periodic Device is fully charged
Pre Alarm Periodic ManDown functionality starts counting down to an event
Sleep Mode Periodic Device is in sleep mode
I Am Alive Periodic Set indication period passed