TRB140 Mobile

From Wiki Knowledge Base | Teltonika
This is the approved revision of this page; it is not the most recent. View the most recent revision.
Main Page > Network products > TRB140 > TRB140 Manual > TRB140 WebUI > TRB140 Mobile

Summary

The Mobile page is used for setting parameters related to the mobile data connection. This page is an overview of the Mobile section for TRB140 gateways.

The information in this page is updated in accordance with the TRB1400_R_00.01.05 firmware version.

Mobile configuration options

The Mobile configuration options section is used to configure main SIM card parameters. Refer to the figure and table below for information on the fields contained in that section.

Networking trb manual mobile mobile configuration v1.png

Field Value Description
Mode NAT | Bridge*; default: NAT Mobile connection operating mode.
  • NAT - the mobile connection uses NAT (network address translation).
  • Bridge - bridges the LTE data connection with LAN. In this mode the router relay the IP address received from the ISP to another LAN device (e.g., computer). Using Bridge mode will disable most of the router’s capabilities and you will only be able to access your router's WebUI with a static IP configuration.
PIN number string; default: none A 4-digit long numeric password used to authenticate the modem to the SIM card.
APN string; default: none An Access Point Name (APN) is a gateway between a GSM, GPRS, 3G or 4G mobile network and another computer network. Depending on the contract, some operators may require you to use an APN just to complete the registration on a network. In other cases, APN is used to get special parameters from the operator (e.g., a public IP address) depending on the contract.
An APN Network Identifier cannot start with any of the following strings:
  • rac;
  • lac;
  • sgsn;
  • rnc;
it cannot end in:
  • .gprs;
and it cannot contain the asterisk symbol (*).
Auth mode CHAP | PAP | None; default: None Authentication method that your GSM carrier uses to authenticate new connections on its network. If you select PAP or CHAP, you will also be required to enter a username and password.
Use Mobile operator DNS off | on; default: on When enabled, the mobile data connection uses DNS servers advertised by the ISP. If turned to 'off', requires you to enter a custom DNS server address instead.
Deny data roaming off | on; default: off When enabled, this option prevents the device from establishing a mobile data connection while not in your home network (roaming conditions).