Difference between revisions of "Template:FMB630 K-Line Data"

From Wiki Knowledge Base | Teltonika
Jump to: navigation, search
(Created page with "K-Line Data functionality allows user to monitor and use incoming data from Tachograph via K-line. Kline periodic record timeout paramater is used to set interval between K-Li...")
 
(K-Line front panel supported with Firmware version 00.02.77 or lower)
(One intermediate revision by the same member not shown)
Line 1: Line 1:
K-Line Data functionality allows user to monitor and use incoming data from Tachograph via K-line. Kline periodic record timeout paramater is used to set interval between K-Line records. Those records aren't included in standard record and will be sent as seperate packet.
+
 
 +
K-Line Data functionality allows user to monitor and use incoming data from Tachograph via K-line. Kline periodic record timeout parameter is used to set interval between K-Line records. Those records aren't included in standard record and will be sent as separate packet.
  
 
To configure any K-Line parameter, every parameter should be separated with comma.  
 
To configure any K-Line parameter, every parameter should be separated with comma.  
Line 7: Line 8:
 
Other Kline properties can be configured in the same logic.
 
Other Kline properties can be configured in the same logic.
  
[[Image:kline_tab.png|none]]
+
 
 +
 
 +
[[Image:kline_tab.png|center]]
 +
 
 +
===K-Line front panel supported with Firmware version 00.02.77 or lower===

Revision as of 15:47, 12 July 2019

K-Line Data functionality allows user to monitor and use incoming data from Tachograph via K-line. Kline periodic record timeout parameter is used to set interval between K-Line records. Those records aren't included in standard record and will be sent as separate packet.

To configure any K-Line parameter, every parameter should be separated with comma. For example, configuring first profile Kline Driver 2 ID by SMS, SMS should look like: “ setparam 1062 1,,,3” (“ setparam 1062 <Priority>,<HighLevel>,<LowLevel>,<generateEvent>”) Driver 2 ID do not have High/Low level so they are skipped by using comma “,,“ Other Kline properties can be configured in the same logic.


Kline tab.png

K-Line front panel supported with Firmware version 00.02.77 or lower