Open main menu
maintenance
IMPORTANT NOTICE: SCHEDULED MAINTENANCE AT 2020-02-19 6:00 AM GMT
Main Page > Fleet management > FMB640 > FMB640 Configuration > FMB640 CAN \ Tachograph

Contents

CAN \ TachographEdit

CAN \ Tachograph are used to configure device when connection of CAN1 and CAN2 BUS lines are performed.

Teltonika recommendations:

  • FMB640 CAN1 connected to vehicle's FMS(J1939) BUS line
  • FMB640 CAN2 connected to vehicle's Tachograph - Instructions can be found on FMB640 and Tachograph Solution wiki page;

Tachograph SettingsEdit


In FMB640 configurator “CAN/Tachograph” section tachograph settings should be set in order to download files.

DDD download source – to which CAN line tachograph is connected;

Tachograph ignition source – which DIN is connected to vehicle ignition ("Ignition" parameter - tachograph ignition source will be the same as configured in "System" -> "Ignition Source");

Error creating thumbnail: Unable to save thumbnail to destination

FMB640 can be wired to Tachograph using instructions provided in FMB640 and Tachograph Solution wiki page.

WEB Tacho SettingsEdit

WEB Tacho Settings are used to configure Tacho WEB server to which device periodically connects.

WEB Tacho Settings:

Status - functionality enabling;
Domain – server domain where files will be send;
Port – server port where files will be send;
Start delay – delay after turning on ignition to start procedure of file sending.

Error creating thumbnail: Unable to save thumbnail to destination

FMS settingsEdit

FMS settings is used to configure FMS source.

If you have FMS wired to FMB640 CAN1, FMS source should be selected as CAN1.
If you have FMS wired to FMB640 CAN2, FMS source should be selected as CAN2.

Error creating thumbnail: Unable to save thumbnail to destination